Flexispot Standing Desk Review …Flexispot 35\” White…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a couple of features that I wasn’t always a substantial fan of:
The plan that the desk was available in was heavy, so bringing it inside was a group effort, but this is simply a repercussion of how strong the Flexispot is.
The hassle-free cable television tray was a bit complicated to install. In the end, you eventually slip it under screws, which wasn’t extremely clear from the instructions.
You will need to purchase an anti-fatigue mat to remain comfortable, but this is a great concept for any standing desks, so I can’t fault Flexispot for that.
When it arrived and I saw how heavy it was, I was both thrilled (because this suggested it was going to be strong) and likewise a little reluctant (due to the fact that we all know how much of a challenge assembling furniture can be).
The good news is, with the help of an educational YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t described well in the directions.
When assembled, I enjoy the streamlined appearance of this desk. I’m confident any of the many varied surfaces that it comes in would look terrific in any office, and the adjustable width makes it simple to fit it in even the tiniest of office.
The peaceful operation and height memory settings make it easy, effective, and peaceful to switch in between sitting and standing as many times as you want throughout the day.
This desk is durable. It can hold up to 335 pounds even while in operation, so if you have a significant desktop (or wish to sleep on it for some reason) it has you covered. It will likewise uniformly disperse weight no matter how out of balance the weight you put on it is, it will not wiggle or wobble.
in that video is pretty kitted out as the desk we’re taking a look at today is pretty fundamental I attempted to get as near that as I might on uplifts site with equivalent setups the flexi area desk we’re taking a look at today will run you about four hundred and ten dollars versus six hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift design is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for transparency flexi spot did send this desk out for evaluation however as you need to understand by now doesn’t affect my review in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping until completion of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can perhaps get lacking even any cable television grommets for travel through the outside carton
for the desktop was not damaged in any way which is utterly unusual because I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted just very rough man if I had actually bought this I ‘d have been on the phone with customer care instantly they did also managed to miss out on drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without inadvertently drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite straightforward the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each part to support motorized function unusually absolutely where any kind of cable television management products whatsoever the frame on this system is a single motor dual phase style versus the double motor three-stage design that comes requirement with the uplift desk this can be upgraded as well to both the dual phase double motor and a three-stage dual motor which pushes the expense of the desk up
an extra 70 dollars the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can range from simply under 28 inches to just over forty seven point six inches so a max I ‘d it is more than high sufficient even for me and I stay at 6 foot for this design does come basic with the control board that permits up-and-down movement plus three memory spots with an LED readout to inform you the desk height the single motor style uses this drive shaft assembly which has to be changed as the width of the desk is adjusted the motor operation itself while it might be slow is really peaceful as in barely audible this outside a price would be the one benefit I would provide this system over the uplift desk and I wish to beware here since this isn’t a hit piece this desk is 240 dollars less expensive than the equivalent uplift model over 35% less expensive even if you update this flexi area test to the double motor three-stage style it still is available in a hundred and seventy dollars more affordable than the uplift however less expensive doesn’t indicate inexpensive this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll certainly give it that but the lateral stability of this desk the horizontal movement at this cost point it’s unacceptable it’s add fuel to the fire here they consist of a little security baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when
this desk sees any lateral motion at all the drive shaft hits this baffle and the sound is definitely infuriating to leading things off I chose to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters got here damaged also my plan for this desk at this moment is to lose the desk top and featured completely and change it with a white laminate lemon table from Ikea and use it as an adjustable image table which you can’t do this frame will accommodate desktops approximately 63 inches large and 31 and a half inches deep so this will roll around the studio make it easier to film items without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift initially that is a financial investment in quality office furniture that will last you this at finest seems like a more affordable imitation of that it just does not feel quality and the distinction between this desk and my main desk is night and day do do not hesitate to take a look at their site too which also feels eerily similar to one of their rivals there’s a wealth of devices you can get for the flexi spot desk approximately and consisting of a foot massager and even a stationary exercise bike and I could spend another 10 minutes of our precious time covering various choices and devices I could however I believe I’m better that they just sent out a basic desk since as a standard desk I’m not a fan of the quality assurance at this rate point and I don’t believe slapping on a lot of bonus is the move when the core product isn’t what it need to be they do offer a 30-day trial if you’re simply morbidly curious and they warranty their desks for 3 years really desk is 5 years and uplift desk is seven years if you are Flexispot 35\” White
in the market for a sit-stand desk they’re fantastic mine’s been a life changer for me both in terms of gaming and performance but I would invest the additional money it’s gon na take to enter a higher end maker like uplift desk or extremely desk and I haven’t personally utilized really desk items so I can’t speak on it but their track record is excellent big thanks to flexi area for sending this out for review regrettably I can not advise this unit and for the record I’m a hundred percent sure they would have happily replaced the parts that I had a concern with seeing as how both the desktop and the casters showed up damaged but from a client standpoint you ‘d probably be actually thrilled to get this in